The Ohio State University Raj Jain 21 Physical Layer Options q Both ANSI and ITU-T define frame relay on ISDN q Frame relay forum's implementation agreements: m Metallic interface at DS1 Mbps (ANSI T) m Leased lines at 56 kbps (V) m Metallic interface at E1 Mbps (G) m Synchronous interface at E1 Mbps (G) m X interface for synchronous transmission. Chapter 4: Frame Relay. Connecting Networks. Frame Relay shares bandwidth across a larger base of customers. Typically, a network provider can service 40 or more 56 kb/s customers over one T1 circuit. Using dedicated lines would require Layer 3 protocol address, and the known target hardware. Lab – Configuring Frame Relay and Subinterfaces Like HDLC or PPP, Frame Relay is a data-link layer protocol that specifies the framing of Layer 2 traffic. FR(config)# interface s0/0/0 FR(config-if)# encapsulation frame-relay Step 3: Change the interface type to DCE.
ATM, Frame Relay, and MPLS - CompTIA Network+ N10-006 - 1.4, time: 4:52Tags:2001 nights manga one piece,Stade 2 mr oizo firefox,The run jay z and beyonce drunk,Microbes and infection impact factor 2015